Home
Downloads
Community
Submit
Marketplace

MM3 modchip soldering points?

System Mods, Hard Mods and Soft Mods - Discuss them here.

MM3 modchip soldering points?

Postby StriderSubzero » Thu Feb 22, 2018 3:40 pm

I have a SCPH-101 model PSOne/Ps1 Slim, and I'm not getting any power after installing the chip. I'm somewhat experienced in soldering so I had no issues soldering to specific points and have done mods in the past of this nature with no problem.

I think I'm misunderstanding the diagram I found, though: imgurdotcom/a/336Yk

On this diagram, it does not indicate pins 2, 4, or 5, so I soldered to points I found using another diagram for a different board. Should I instead desolder those points since they're not included in this diagram?

The other question I have is, what is meant by the red circle pointing to the power jack and the red circle on top of the chip (to the left of point 8)? I did not solder anything to the power jack.

I would appreciate any guidance here. Thank you!
  • 0

StriderSubzero Newbie
 
Posts: 1
Joined: Thu Feb 22, 2018 3:35 pm
Reputation: 0

Re: MM3 modchip soldering points?

Postby WalkingDead » Thu Feb 22, 2018 8:02 pm

  • 0

WalkingDead 3
 
Posts: 58
Joined: Mon Jan 09, 2017 6:12 pm
Reputation: 130


Return to System Modding



Who is online

Users browsing this forum: No registered users and 11 guests



Home | Legal Notice | DMCA Policy | DMCA File Removal Center | Contact